Editing: if_ether.h

/* SPDX-License-Identifier: GPL-2.0+ WITH Linux-syscall-note */ /* * INET An implementation of the TCP/IP protocol suite for the LINUX * operating system. INET is implemented using the BSD Socket * interface as the means of communication with the user level. * * Global definitions for the Ethernet IEEE 802.3 interface. * * Version: @(#)if_ether.h 1.0.1a 02/08/94 * * Author: Fred N. van Kempen, <waltje@uWalt.NL.Mugnet.ORG> * Donald Becker, <becker@super.org> * Alan Cox, <alan@lxorguk.ukuu.org.uk> * Steve Whitehouse, <gw7rrm@eeshack3.swan.ac.uk> * * This program is free software; you can redistribute it and/or * modify it under the terms of the GNU General Public License * as published by the Free Software Foundation; either version * 2 of the License, or (at your option) any later version. */ #ifndef _LINUX_IF_ETHER_H #define _LINUX_IF_ETHER_H #include <linux/types.h> /* * IEEE 802.3 Ethernet magic constants. The frame sizes omit the preamble * and FCS/CRC (frame check sequence). */ #define ETH_ALEN 6 /* Octets in one ethernet addr */ #define ETH_TLEN 2 /* Octets in ethernet type field */ #define ETH_HLEN 14 /* Total octets in header. */ #define ETH_ZLEN 60 /* Min. octets in frame sans FCS */ #define ETH_DATA_LEN 1500 /* Max. octets in payload */ #define ETH_FRAME_LEN 1514 /* Max. octets in frame sans FCS */ #define ETH_FCS_LEN 4 /* Octets in the FCS */ #define ETH_MIN_MTU 68 /* Min IPv4 MTU per RFC791 */ #define ETH_MAX_MTU 0xFFFFU /* 65535, same as IP_MAX_MTU */ /* * These are the defined Ethernet Protocol ID's. */ #define ETH_P_LOOP 0x0060 /* Ethernet Loopback packet */ #define ETH_P_PUP 0x0200 /* Xerox PUP packet */ #define ETH_P_PUPAT 0x0201 /* Xerox PUP Addr Trans packet */ #define ETH_P_TSN 0x22F0 /* TSN (IEEE 1722) packet */ #define ETH_P_ERSPAN2 0x22EB /* ERSPAN version 2 (type III) */ #define ETH_P_IP 0x0800 /* Internet Protocol packet */ #define ETH_P_X25 0x0805 /* CCITT X.25 */ #define ETH_P_ARP 0x0806 /* Address Resolution packet */ #define ETH_P_BPQ 0x08FF /* G8BPQ AX.25 Ethernet Packet [ NOT AN OFFICIALLY REGISTERED ID ] */ #define ETH_P_IEEEPUP 0x0a00 /* Xerox IEEE802.3 PUP packet */ #define ETH_P_IEEEPUPAT 0x0a01 /* Xerox IEEE802.3 PUP Addr Trans packet */ #define ETH_P_BATMAN 0x4305 /* B.A.T.M.A.N.-Advanced packet [ NOT AN OFFICIALLY REGISTERED ID ] */ #define ETH_P_DEC 0x6000 /* DEC Assigned proto */ #define ETH_P_DNA_DL 0x6001 /* DEC DNA Dump/Load */ #define ETH_P_DNA_RC 0x6002 /* DEC DNA Remote Console */ #define ETH_P_DNA_RT 0x6003 /* DEC DNA Routing */ #define ETH_P_LAT 0x6004 /* DEC LAT */ #define ETH_P_DIAG 0x6005 /* DEC Diagnostics */ #define ETH_P_CUST 0x6006 /* DEC Customer use */ #define ETH_P_SCA 0x6007 /* DEC Systems Comms Arch */ #define ETH_P_TEB 0x6558 /* Trans Ether Bridging */ #define ETH_P_RARP 0x8035 /* Reverse Addr Res packet */ #define ETH_P_ATALK 0x809B /* Appletalk DDP */ #define ETH_P_AARP 0x80F3 /* Appletalk AARP */ #define ETH_P_8021Q 0x8100 /* 802.1Q VLAN Extended Header */ #define ETH_P_ERSPAN 0x88BE /* ERSPAN type II */ #define ETH_P_IPX 0x8137 /* IPX over DIX */ #define ETH_P_IPV6 0x86DD /* IPv6 over bluebook */ #define ETH_P_PAUSE 0x8808 /* IEEE Pause frames. See 802.3 31B */ #define ETH_P_SLOW 0x8809 /* Slow Protocol. See 802.3ad 43B */ #define ETH_P_WCCP 0x883E /* Web-cache coordination protocol * defined in draft-wilson-wrec-wccp-v2-00.txt */ #define ETH_P_MPLS_UC 0x8847 /* MPLS Unicast traffic */ #define ETH_P_MPLS_MC 0x8848 /* MPLS Multicast traffic */ #define ETH_P_ATMMPOA 0x884c /* MultiProtocol Over ATM */ #define ETH_P_PPP_DISC 0x8863 /* PPPoE discovery messages */ #define ETH_P_PPP_SES 0x8864 /* PPPoE session messages */ #define ETH_P_LINK_CTL 0x886c /* HPNA, wlan link local tunnel */ #define ETH_P_ATMFATE 0x8884 /* Frame-based ATM Transport * over Ethernet */ #define ETH_P_PAE 0x888E /* Port Access Entity (IEEE 802.1X) */ #define ETH_P_AOE 0x88A2 /* ATA over Ethernet */ #define ETH_P_8021AD 0x88A8 /* 802.1ad Service VLAN */ #define ETH_P_802_EX1 0x88B5 /* 802.1 Local Experimental 1. */ #define ETH_P_PREAUTH 0x88C7 /* 802.11 Preauthentication */ #define ETH_P_TIPC 0x88CA /* TIPC */ #define ETH_P_LLDP 0x88CC /* Link Layer Discovery Protocol */ #define ETH_P_MRP 0x88E3 /* Media Redundancy Protocol */ #define ETH_P_MACSEC 0x88E5 /* 802.1ae MACsec */ #define ETH_P_8021AH 0x88E7 /* 802.1ah Backbone Service Tag */ #define ETH_P_MVRP 0x88F5 /* 802.1Q MVRP */ #define ETH_P_1588 0x88F7 /* IEEE 1588 Timesync */ #define ETH_P_NCSI 0x88F8 /* NCSI protocol */ #define ETH_P_PRP 0x88FB /* IEC 62439-3 PRP/HSRv0 */ #define ETH_P_CFM 0x8902 /* Connectivity Fault Management */ #define ETH_P_FCOE 0x8906 /* Fibre Channel over Ethernet */ #define ETH_P_IBOE 0x8915 /* Infiniband over Ethernet */ #define ETH_P_TDLS 0x890D /* TDLS */ #define ETH_P_FIP 0x8914 /* FCoE Initialization Protocol */ #define ETH_P_80221 0x8917 /* IEEE 802.21 Media Independent Handover Protocol */ #define ETH_P_HSR 0x892F /* IEC 62439-3 HSRv1 */ #define ETH_P_NSH 0x894F /* Network Service Header */ #define ETH_P_LOOPBACK 0x9000 /* Ethernet loopback packet, per IEEE 802.3 */ #define ETH_P_QINQ1 0x9100 /* deprecated QinQ VLAN [ NOT AN OFFICIALLY REGISTERED ID ] */ #define ETH_P_QINQ2 0x9200 /* deprecated QinQ VLAN [ NOT AN OFFICIALLY REGISTERED ID ] */ #define ETH_P_QINQ3 0x9300 /* deprecated QinQ VLAN [ NOT AN OFFICIALLY REGISTERED ID ] */ #define ETH_P_EDSA 0xDADA /* Ethertype DSA [ NOT AN OFFICIALLY REGISTERED ID ] */ #define ETH_P_DSA_8021Q 0xDADB /* Fake VLAN Header for DSA [ NOT AN OFFICIALLY REGISTERED ID ] */ #define ETH_P_IFE 0xED3E /* ForCES inter-FE LFB type */ #define ETH_P_AF_IUCV 0xFBFB /* IBM af_iucv [ NOT AN OFFICIALLY REGISTERED ID ] */ #define ETH_P_802_3_MIN 0x0600 /* If the value in the ethernet type is less than this value * then the frame is Ethernet II. Else it is 802.3 */ /* * Non DIX types. Won't clash for 1500 types. */ #define ETH_P_802_3 0x0001 /* Dummy type for 802.3 frames */ #define ETH_P_AX25 0x0002 /* Dummy protocol id for AX.25 */ #define ETH_P_ALL 0x0003 /* Every packet (be careful!!!) */ #define ETH_P_802_2 0x0004 /* 802.2 frames */ #define ETH_P_SNAP 0x0005 /* Internal only */ #define ETH_P_DDCMP 0x0006 /* DEC DDCMP: Internal only */ #define ETH_P_WAN_PPP 0x0007 /* Dummy type for WAN PPP frames*/ #define ETH_P_PPP_MP 0x0008 /* Dummy type for PPP MP frames */ #define ETH_P_LOCALTALK 0x0009 /* Localtalk pseudo type */ #define ETH_P_CAN 0x000C /* CAN: Controller Area Network */ #define ETH_P_CANFD 0x000D /* CANFD: CAN flexible data rate*/ #define ETH_P_CANXL 0x000E /* CANXL: eXtended frame Length */ #define ETH_P_PPPTALK 0x0010 /* Dummy type for Atalk over PPP*/ #define ETH_P_TR_802_2 0x0011 /* 802.2 frames */ #define ETH_P_MOBITEX 0x0015 /* Mobitex (kaz@cafe.net) */ #define ETH_P_CONTROL 0x0016 /* Card specific control frames */ #define ETH_P_IRDA 0x0017 /* Linux-IrDA */ #define ETH_P_ECONET 0x0018 /* Acorn Econet */ #define ETH_P_HDLC 0x0019 /* HDLC frames */ #define ETH_P_ARCNET 0x001A /* 1A for ArcNet :-) */ #define ETH_P_DSA 0x001B /* Distributed Switch Arch. */ #define ETH_P_TRAILER 0x001C /* Trailer switch tagging */ #define ETH_P_PHONET 0x00F5 /* Nokia Phonet frames */ #define ETH_P_IEEE802154 0x00F6 /* IEEE802.15.4 frame */ #define ETH_P_CAIF 0x00F7 /* ST-Ericsson CAIF protocol */ #define ETH_P_XDSA 0x00F8 /* Multiplexed DSA protocol */ #define ETH_P_MAP 0x00F9 /* Qualcomm multiplexing and * aggregation protocol */ /* * This is an Ethernet frame header. */ /* allow libcs like musl to deactivate this, glibc does not implement this. */ #ifndef __UAPI_DEF_ETHHDR #define __UAPI_DEF_ETHHDR 1 #endif #if __UAPI_DEF_ETHHDR struct ethhdr { unsigned char h_dest[ETH_ALEN]; /* destination eth addr */ unsigned char h_source[ETH_ALEN]; /* source ether addr */ __be16 h_proto; /* packet type ID field */ } __attribute__((packed)); #endif #endif /* _LINUX_IF_ETHER_H */

SIMPAN BATAL